10.INSTALL THE HOOD
Place the hood at its location. Using a pen, mark the position of the screw (smaller part of the keyholes [A]). Remove the hood
and install (4) 1/2" double thread screws at marked positions, leaving a 1/8" gap.
Place the hood under the cabinet and slide it in position. Make sure the adapter/damper enters the ducting and the damper
opens freely (UP27I Series range hood only), or ensure ducting connects to rough-in plate (UP27E Series range hood only).
Secure the hood by tightening the screws completely. Install the last 1/2" double thread screws in the remaining holes [B].
UP27I H
OOD RETAINING SCREWS LOCATION
HD0213
11.INSTALL THE BLOWER
Refer to instructions included with blower.
Once the blower is installed, plug the blower cord (A) into the female receptacle
and the power supply cord (B) onto the male connector inside the hood.
Do not plug the two cords into each other.
12.REINSTALL THE PAN
Using a Phillips screwdriver and the pan retaining screws, reinstall the pan (previously removed in step 6) inside the hood
(shaded parts on illustration below).
UP27I R
A
HD0207
(EXTERIOR BLOWER, UP27E SERIES RANGE HOOD ONLY)
WARNING
!
ETAINING SCREWS LOCATION
A
A A
B
B
B
A: no. 8 x 3/8"
B: no. 6 x 1/2"
UP27E H
OOD RETAINING SCREWS LOCATION
A
B
A
B
HE0078
UP27E R
ETAINING SCREWS LOCATION
A
A: no. 8 x 3/8"
- 11 -
A
B
A
A
A