Télécharger Imprimer la page

Operating Instructions - imacon Flextight Precision II Guide De L'utilisateur

Masquer les pouces Voir aussi pour Flextight Precision II:

Publicité

Les langues disponibles
  • FR

Les langues disponibles

Hardware ReferenceÑFlextight Precision II
14

Operating Instructions

Operating Instructions
1.
Install the scanner as described above. Install the software on your
computer as described in the tutorial. Turn on the scanner by press-
ing the red button on the front panel.
2.
Select the magnetic original holder that matches your original
¥ For transparencies, choose one of the holders that has a square
¥ For reßectives, select the large A4/letter-size holder with the
3.
If you are using the reßective holder, then pull out the support at
the front of the scanner below the light table.
4.
Place the original holder with the slotted tab facing into the scan-
ner.
¥ For transparencies, the ßexible magnetic layer must face
¥ For reßectives, the clear plastic sheet must face upwards.
¥ Guides are supplied on either side of the light table for both the
5.
Slide the holder gently into the slot at the top of the light table. It
will slip about 1/2 cm (1/4 inch) into a slot at the top of the light
table. Do not press too hard. It slips in very easily and is held in
place by a magnet. To remove the holder, simply slide it back out.
6.
Lift the top layer of the original holder and place your original as
follows:
¥ For transparencies, place your original with the emulsion side
¥ For reßectives, make sure that no part of the original extends
hole in it. The original must completely Þll the hole with no
edges showing. Also, no edges of the original must extend past
the outer edges of the holder.
clear plastic layer.
upwards.
transparency and reßective original holders.
down. The original must completely Þll the hole with no edges
showing and with a minimum overlap of 2mm along each edge.
Also, no edges of the original must extend past the outer edges
of the holder. Use the light table to help line up the image.
past the edge of the holder. Use the lines printed on the holder to
line up the image. Handle the clear plastic layer only by the
Imacon Flextight Precision II UserÕs Guide

Publicité

loading