Technical Data; Electrical Hook-Up - Caple CM209SS Manuel D'instructions

TECHNICAL DATA

Power supply
Maximum absorbed power
Microwave power
Grill
Hot air
Microwave frequency

ELECTRICAL HOOK-UP

Before making the electrical hook-up, make sure that:
- the characteristics of the electrical system satisfy what is shown on the serial number plate applied to the front
of the oven;
- the electrical system has an effect earth connection conforming to standards and current law.
The earth connection is required by law.
The cable must not, at any point, reach a temperature greater than 50 °C above the ambient temperature.
This oven must be connected to the supply by a supply cord fitted with an appropriately rated plug that is
compatible with the socket-outlet fitted to the final sub-circuit in the fixed wiring that is intended to supply this
oven.
If a fixed appliance does not have a power cord and plug, or another device that ensures disconnection from
the mains, with an opening distance of the contacts that allows complete disconnection under the conditions
of excessive voltage category III, such disconnection devices must be provided in the power supply mains
conforming to the installation rules.
The omnipolar socket or switch must be easy to reach when the appliance is installed.
NOTE: The manufacturer declines all liability if the usual accident prevention standards and the above instructions
are not followed.
H05RR-F 3x1,5 mm²
H05VV-F 3x1,5 mm²
H05RN-F 3x1,5 mm²
H05V2V2-F 3x1,5 mm²
220-240 V~, 50Hz
3200 W
900 W
1500 W
1500 W
2450 MHz
TYPE AND MINIMUM DIAMETER OF THE CABLES
57
SASO
H05RR-F 3x2,5 mm²
H05VV-F 3x2,5 mm²
H05RN-F 3x2,5 mm²
H05V2V2-F 3x2,5 mm²
GB