Introduction To The Oven - Caple CM209SS Manuel D'instructions

INTRODUCTION TO THE OVEN

Dear Customer, your new oven is controlled by an electronic board that constantly monitors its operation to
improve its performance.
The touch controls are state-of-the-art, precise and reliable.
The interface is elegant, orderly and discrete, more intuitive than ever!
A few buttons, many functions and no combination or sequence is difficult to enter, so you can concentrate on
following the recipe and the oven is ready in two clicks!
Installation and hook-up
Dear Customer, this oven is a sophisticated electronic appliance, classified as a durable good. Its installation
requires qualified professionals for both the hook-up of the power line and itsplacement in the kitchen counter.
(SEE ASSEMBLY INSTRUCTIONS ON PAGE 56)
Before hook-up
When the oven is connected to the electric mains for the first time, the display will ask you to select your language;
use the buttons to select the language you want;
use the button to confirm the choice;
((from now on, the language choice will remain fixed even when their are power outages).
Now, it goes into demonstration mode
Demonstration mode
This is the mode that the oven is normally in every time that there is a power failure and, consequently, when it is
first hooked-up:
the purpose is to show how you can control it with a recorded sequence of commands.
In this mode, the oven is never REALLY turned on, i.e., the heating elements are never powered!
The control panel is INACTIVE and, so, the oven will not respond to commands!
To disable the demonstration mode, touch the light
symbol for five seconds:
operation and ready for turning on.
Now you can set the time but it is not necessary for
turning on the oven.
39
the control will go to normal
GB