Joie stages fx Mode D'emploi page 12

5. Connect the tether hook
securely to the anchorage fitting.
!
USE Top Tether for forward facing
mode installation if vehicle is
equipped with a Tether anchorage
fitting and vehicle requirements are
met (see vehicle owner's manual).
6. Correctly assembled ISOFIX (ISOFIX
attachments and top tether) is shown
as
34
!
Make sure that the tether hook is
securely attached to the anchorage
fitting. The colors of the indicators
on tether strap adjuster should be
-1
completely green.
34
!
If recline angle is adjusted, check
the tension on the top tether, or
loosen to adjust angle then
re-tension.
Removing the base
1. To remove from the vehicle press
the ISOFIX attachments release
-1
button and pull the base back
35
-2
from the seat.
35
21
33
33
34
1
35
2
1
2. Then press and release the
connectors from the vehicle's
ISOFIX.
36
!
The ISOFIX attachments are
retracted completely back into
base.
37
!
When not in use, Top Tether MUST
be properly stored. To make sure
the top tether is properly stored
away, remove any slack in strap to
avoid the top tether swinging
around when the vehicle is in
progress.
38
!
When the pocket is not used,
please store it properly.
36
2
1
37
2
2
1
38
22