Joie stages fx Mode D'emploi page 10

a. For installation with 3-point-belt
1. Thread the safety belt through
two seat belt back slots at the back
of the child restraint.
22
2. Buckle the safety belt.
23
3. While pressing the child restraint,
pull the belts to fasten the child
restraint tightly and securely. 24
!
The child restraint can not be used
if the vehicle safety belt buckle
(female buckle end) is too long to
anchor the child restraint securely.
-1
24
17
22
23
24
4. Open the lock-off device and insert
the safety belt through it.
25
!
Please check if the child restraint is
installed tightly by moving the child
restraint back and forth at the vehicle
belt path. (child restraint should not
move more than 25mm/1").
The assembled safety belt is shown as
!
Shoulder belt passes through Lock-off Device, as
!
Waist belt passes through the seat belt back slots, as
!
The vehicle buckle tongue is engaged with the buckle correctly,
-3
as
26
26
!
When not in use, Top Tether MUST be properly stored. To make sure the
top tether is properly stored away, remove any slack in strap to avoid the
top tether swinging around when the vehicle is in progress.
25
26
-1
26
-2
26
1
2
3
38
18