Product Maintenance - Fellowes POWERSHRED M-8C Mode D'emploi

BASIC SHREDDING OPERATION
PAPER/CARD
1
Continuous operation:
Plug in and put
NOTE: Shredder runs briefly
disconnect power
after each pass to clear entry.
switch in ON (I) position
Continuous operation beyond
5 minutes will trigger a
30-minute cool down period.

PRODUCT MAINTENANCE

OILING SHREDDER
performance. If not oiled, a machine may
experience diminished sheet capacity, intrusive
noise when shredding and could ultimately
recommend you oil your shredder each time
you empty your waste bin.
*Only use a non-aerosol vegetable oil in long nozzle container such as Fellowes 35250
TROUBLESHOOTING
Overheat Indicator: When the Overheat Indicator is illuminated, the shredder has exceeded its maximum operating temperature
time. See Basic Shredding Operation for more information about the continuous operation and recovery time for this shredder.
PAPER JAM
1 2
Set to Reverse Alternate slowly back and forth
( ) for
2-3 seconds
LIMITED PRODUCT WARRANTY
Limited Warranty: Fellowes, Inc. ("Fellowes") warrants the parts of the machine to be free of
defects in material and workmanship and provides service and support for 2 years from the date of
purchase by the original consumer. Fellowes warrants the cutting blades of the machine to be free
from defects in material and workmanship for 3 years from the date of purchase by the original
consumer. If any part is found to be defective during the warranty period, your sole and exclusive
warranty does not apply in cases of abuse, mishandling, failure to comply with product usage
standards, shredder operation using an improper power supply (other than listed on the label), or
unauthorized repair. Fellowes reserves the right to charge the consumers for any additional costs
2
Set to Auto-On ( )
Safety Lock prevents accidental operation.
FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE
1 2
Set to Off ( )
3 4
Set to Off ( )
and unplug
3 4
When finished
Feed paper/card
shredding set to
straight into paper
OFF ( )
entry and release
3
Set to Reverse ( )
* Apply oil
for 2-3 seconds
across entry
5 6
Gently pull uncut Set to Auto-On (
and resume shredding
paper from paper
entry. Plug in.
incurred by Fellowes to provide parts or services outside of the country where the shredder is initially
service under this warranty, please contact us or your dealer.
)
3