Control Panel Functions; Display Types - Struers Exotom-100 Mode D'emploi

Control Panel Functions

Name Key
1
Power
POWER
2
s
START
3
o
STOP
4
U
CUTTING
MODE

Display Types

Exotom-100
Instruction Manual
Function
Lights when the Main Switch has
been turned to ON.
Starts the machine and recirculation
unit.
Stops the machine and recirculation
unit.
Push button to select desired cutting
mode: Direct cutting, ExciCut,
AxioCut/Step, AxioCut/Sweep.
The Cutting Display will be shown on the Control Panel when
turning Exotom-100 on. This display is for everyday use.
By pressing the MENU m button once, the CONFIGURATION
menu will appear on the display. This menu will normally only be
accessed during installation.
Name Key
5
m
MENU
6
JOYSTICK
7
MULTI-
FUNCTION
KNOB
Function
Push button to toggle between
Cutting menu (daily use) and
Configuration menu (basic settings).
Move up- or downwards to position
cut-off wheel.
Push knob to select function. Turn
knob to adjust settings.
11