Ignition - Samsung NX58K9850S Serie Manuel D'utilisation

Cooktop
Gas burners
LR RR
C
LF RF
Position Purpose
Right Front (RF) Power heating
22,000 BTU
Right Rear (RR) Low simmering
5,000 BTU
Center (C) Grilling/Griddling
9,500 BTU
Left Front (LF) Quick heating
15,000 BTU
Left Rear (LR) General heating/
9,500 BTU Low simmering
* Tomato sauce needs to be stirred while it is simmering.
18 English
Each burner has a corresponding knob
that lets you to set the flame level from LO
to HI. In addition, each burner knob has a
Lite setting. Turning a knob to Lite ignites
the corresponding burner. The burner
indicators are located above each knob
and show which burner the knob controls.
Each burner is designed for specific cooking
purposes. See the table below.
Food type Characteristics
Boiling food Maximum output
Chocolate, Delicate food that
casseroles, sauces requires low heat
for a long time
Pancakes, General-purpose
hamburgers, cooking
fried eggs, hot
sandwiches
General General-purpose
cooking
General food, General-purpose
casseroles, tomato cooking
sauce*

Ignition

CAUTION
The knob LED indicates if a burner knob has been turned on.
It does not indicate if the burner flame is on.
Check for an actual flame, whether the knob LED is on or off.
2
1
Manual ignition
If there is a power failure, you can ignite the burner manually. Use caution when
doing this.
1. Hold a long gas grill lighter to the surface burner you want to light.
2. Push in the control knob for that burner, and then turn it to the Lite position.
Turn on the grill lighter to ignite the burner.
3. After the burner is lit, turn the control knob to adjust the flame level.
Flame level
The flames on the burners should always stay under the cookware, and should not
extend beyond the cookware bottom at any time.
WARNING
• Flames larger than the cookware bottom may result in a fire or physical injury.
• When you set a burner to simmer, do not turn the burner knob quickly. Watch the
flame to make sure it stays on.
Make sure all surface burners are properly
installed. To light a burner:
1. Push in the control knob, and then turn
it to the Lite position. The knob LED is
on and you will hear a "clicking" sound
indicating the electronic ignition system
is working properly.
2. After the surface burner lights, turn
the control knob to shift it out of the
Lite position and turn off the electronic
ignition system.
3. Turn the control knob to adjust the flame
level.