Maintenance; Cleaning - Samsung NX58K9850S Serie Manuel D'utilisation

Oven remote control using the Samsung Smart Home app
Error Check • Automatically recognize errors.
• Monitor the current temperature and reset the
Temp Probe
probe setting.
• If is not shown in the display, you are still able to monitor the oven and
cooktop status and turn the oven off.
WI-FI On/Off
If you set the WI-FI mode to Off, mobile devices cannot connect to the range.
3
2 2
1
1
NOTES
• Opening the oven door or pressing Smart Control will delete
and prevent most of the remote functions from operating.
• When oven cooking is finished or cancelled,
• For safety reasons, you cannot turn on the gas oven remotely.
• For safety reasons, you must specify the cooking time to enable remote control.
• The oven continues operating even if the Wi-Fi connection is lost.
• Smart Control will not work properly if the Wi-Fi Connection is unstable.
• See the Samsung Smart Home App manual for detailed information.
1. Press the Options pad, and then 8 on the
number pad.
2. Press 1 (On) or 2 (Off) on the number
pad.
3. Press the START/SET pad to save the
changes.
from the display
is removed from the display.

Maintenance

Cleaning

Control panel
First, lock the control panel and the door to prevent accidental operations and/or
product tipping.
1. Press and hold the START/SET pad for 3 seconds to lock both the control panel
and the door.
2. Clean the control panel using a soft cloth dampened with plain water, warm
soapy water, or glass cleaner. Do not spray cleansers directly onto the control
panel.
3. When done, press and hold the START/SET pad again for 3 seconds.
WARNING
• Make sure the control panel turns off and all surfaces of the range are cool
before cleaning. Otherwise, you can get burned.
• If the range has been moved away from the wall, make sure the anti-tip device is
reinstalled properly when the range has been put into place again. Otherwise, the
range may tip over, causing physical injuries.
• Do not use steel-wool or abrasive cleansers of any kind. These can scratch or
damage the surface.
Stainless steel surface
1. Remove any spills, spots, and grease stains using a soft, wet cloth.
2. Apply an approved stainless steel cleanser to a cloth or paper towel.
3. Clean one small area at a time, rubbing with the grain of the stainless steel if
applicable.
4. When done, dry the surface using a soft, dry cloth.
5. Repeat steps 2 through 4 as many times as necessary.
CAUTION
• Do not use a steel-wool pad or abrasive cleanser on stainless steel surfaces. It
will scratch the surface.
• Do not spray any type of cleanser into the manifold holes. The ignition system is
located in those holes and must be kept free of moisture.
English 41