Pioneer KURO PDP-6020FD Mode D'emploi page 68

Additional Picture and Sound Adjustment Options
04
AV Source - No Signal
To save energy and extend the life of your flat panel TV, the panel can enter Standby automatically if the AV source
signal fails for 15 consecutive minutes. At five minutes before and at every minute after that, a warning message
appears on the screen. When the final minute elapses, the panel switches to Standby.
To have the panel switch to Standby when an AV source signal fails, follow the steps below.
1 ) Access the
2 ) Select No Signal off
3 ) Select Enable
4 ) Press HOME MENU to exit the menu.
Note: The flat panel TV may switch to Standby when there is noise (signal interference) at the end of a broadcast
schedule (channel goes off-air).
AV Source - Non-Operational
To save energy and extend the life of your flat panel TV, the panel can enter Standby automatically if there are no
commands from the AV source for three consecutive hours. At five minutes before and at every minute after that,
a warning message appears on the screen. When the final minute elapses, the panel switches to Standby.
For the panel to enter Standby automatically when there are no commands from the AV source, follow the steps
below.
1 ) Access the
No Operation off
2 ) Select
Enable
3 ) Select
4 ) Press HOME MENU to exit the menu.
PC Source -Power Management
When receiving signals from a PC, the panel can enter Standby automatically if the signal fails. Follow the steps
below to activate this function.
1 ) Access the
Power Management
2 ) Select
3 ) Select an option from the submenu.
Note: Pressing the remote's
4 ) Press HOME MENU to exit the menu.
These power management options are unavailable when a PC is connected to the panel through the HDMI port/
terminal.
68
En
Power Control
through the
from the Power Control menu.
to activate the AV Signal off power function.
Power Control
through the
from the Power Control menu.
from the No Operation off menu.
Power Control
through the
from the Power Control menu.
Option
Off no power management (default)
On panel enters Standby when no signal is received
from the PC for
no effect on the panel
TV a or the panel's
Setup
.
Setup
.
Setup
.
Description
eight minutes ; using the PC has
reactivates the flat panel TV.
STANDBY/ON