Add A Computer (Pc); Automatic Image Position And Clock Adjustments; Manual Image Position And Clock Adjustments - Pioneer KURO PDP-6020FD Mode D'emploi

Use Other Equipment With Your Flat Panel TV
05

5.12 Add a Computer (PC)

Use the panel's PC terminals to connect a personal computer. The PC input terminals are DDC2B-compatible;
however, the Plug & Play function may not operate properly. When connected to a PC, the panel automatically
identifies the input signal type. If the panel fails to see the PC or the picture is unclear, activate the Auto Setup
function.

5.12.1 Automatic Image Position and Clock Adjustments

When connected to a PC, the image position and clock frequency can be adjusted. The Auto Setup option
automatically adjusts these options but the image position and clock can be adjusted manually too. This section
covers the automatic setup function and the following section covers how to manually adjust image position and
clock.
The AV source device must be connected to the flat panel TV and turned on for these options to work. To use Auto
Setup to automatically adjust image position and clock, follow the steps below.
1 ) Access the
2 ) Select Auto Setup
The function begins as soon as the selection is made. However, depending on the image, the position may
not change after an adjustment.
3 ) Press HOME MENU to exit the menu.
Note: This function is unavailable when the PC is connected to the HDMI terminal.
When Auto Setup finishes, the message, "Auto Setup Completed" appears on screen. However, if the setup fails
to adjust the image, the message still appears if other factors affect the change. Auto Setup may fail with a PC
image composed of similar patterns or a monochrome picture. If Auto Setup fails to correct the image position
and clock, change the PC image and try again.

5.12.2 Manual Image Position and Clock Adjustments

Usually Auto Setup for a PC is the best practice for adjusting the image position and clock. However, to personally
optimize the image position and clock, follow the steps below.
1 ) Access the
Manual Setup
2 ) Select
3 ) Select an option to adjust.
4 ) Use the up/down arrow buttons (/) to adjust the option.
Clock and Phase also accept the left/right arrows (
5 ) Press HOME MENU to exit the menu.
112
En
Option through the Setup .
from the Option menu.
Option Setup
through the .
from the Option menu.
H/V Position Adjust
Clock
Phase
Reset
: +120
: +15
/
) for changes.