Install The Panel Using A Stand; Use Or Remove The Included Stand - Pioneer KURO PDP-6020FD Mode D'emploi

Install Your Flat Panel TV
02

2.2 Install the Panel Using a Stand

2.2.1 Use or Remove the Included Stand

The PDP-5020FD ships with the Pioneer table top stand (stand) attached. Attach the included stand to the panel
for the PDP-6020FD. For PDP-5020FD, attach the falling prevention metal fittings after placing the panel to stand
upright.
Attach the Stand to the Panel
1 ) Detach the speaker if it has already been added.
Refer to "Attach/Detach the Speaker" on page 18 for assistance.
2 ) Lay the flat panel TV down on a raised surface with the stand base hanging over the edge.
3 ) Place all stand parts on a soft cloth to avoid scratching.
If you are mounting the PDP-6020FD continue with Steps 4 and 5. If you are mounting the PDP-5020FD skip
to Step 7.
4 ) Turn the base cover over so that the bottom is facing up.
5 ) Insert the stand supports (legs) into the base cover.
Please carefully install the supports (left and right) so that they are in the correct positions. Misaligned supports
can damage the base and/or the supports.
6 ) Tighten the base screws to lock the supports in to place.
Note: Assemble the stand with a soft sheet placed under the base cover. If a sheet is not laid before assembly,
the front surface of the base cover may be scratched.
16
En
Installation screws
(M4 × 35 mm: black)
Falling prevention
metal fitting
Do not handle the flat panel TV on a wagon or pallet that is
smaller than its stand. The stand will bend.
Screws
(4 x 10 mm: silver)
Front
Completed
stand
(PDP-5020FD)
Screws
(4 x 10 mm: silver)
Rear
Base cover
Sheet