Safety Instructions - Laevo V2.57 Mode D'emploi

4

Safety Instructions

6
DANGER!
Reduced efficiency of CPR or defibrillator
Expose chest before CPR: Pull apart the two halves of the chest pad. Release the front belt
f
buckle. Push the halves outwards.
6
WARNING!
Risk of increased discomfort or pain
Stop using the product.
f
When the pain is gone, build up the frequency and duration of the usage again.
f
Do not wear the Laevo directly on exposed skin.
f
6 WARNING!
Loss of functionality, including sudden loss of support
Do not use a damaged product.
f
Do not use flammable substances (e.g. matches, lighters, candles) near the Laevo. The
f
Laevo is not flame retardant.
Keep the Laevo dry.
f
Keep moving parts free of any fluids.
f
Keep moving parts free from sand, dust and debris.
f
2
TIP: For some applications and parts a protective cover is available. Contact your supplier or
Laevo.
6 WARNING!
Risk of sudden loss of support. If this occurs, your hands or head can suddenly move (a few
centimeters)
Do not use the device where sudden hand or head movements could lead to injury to you
f
or somebody else.
6 WARNING!
Risk of sudden loss of support
Take caution not to accidentally press buttons, for example by bumping.
f
Do not press buttons on the Laevo while another is using it.
f
6 WARNING!
Misuse can lead to cutting or crushing injury
Do not place your fingers near rotation points while bending.
f
Do not allow fingers from others near the Laevo during use (except setup). Keep the Laevo
f
away from children and pets.
6
WARNING!
Risk of sudden loss of support
Check the date on the torso structures. If the usage of the torso structures exceeds 3 years,
f
stop using the Laevo. Contact the supplier or replace parts.
6
WARNING! Structures loaded for more than 250.000 cycles or for more than 3 years.
Risk of sudden loss of support
Do not use the Laevo.
f
Contact the supplier or Laevo. Follow the advice.
f
Wearable back support for repetitive bending and bended posture
Laevo worn during CPR or defibrillator use
Discomfort or pain during use
Use of damaged product
Failure of the device while bending
Pushing buttons while bending
Fingers near smart joint while bending
Use of out-of-date parts
EN
9