Using Your Blood Pressure Monitor; Inserting The Batteries; Using An Mains Adapter (Special Accessory) - Marque Verte Digitensio PRO BP 3BM1-4D Mode D'emploi

4. Using your Blood Pressure Monitor

4.1. Inserting the batteries

Insert batteries immediately after unpacking the device.
The battery compartment is located on the back of the
device (see illustration).
a) Remove cover as illustrated
b) Insert the batteries (4 x size AA 1,5V), observing the
indicated polarity.
c) If a battery warning
batteries are almost flat and must be replaced; After
battery warning
work until batteries have been replaced.
Attention!
• After the battery warning appears, the device is blocked until the batteries have been replaced.
• Please use «AA» Long-Life or Alkaline 1.5 V Batteries. The use of 1.2 V Accumulators is not
recommended.
• If the blood pressure monitor is left unused for long periods, please remove the batteries from the
device.

4.2. Using an mains adapter (special accessory)

This blood pressure monitor can be operated with the mains adapter (output 6 V DC / 600 mA, DIN plug).
a) Plug the plug into the socket at the back of the
instrument.
b) Plug the mains adapter into a 230 V or 110 V power
socket. Test that power is available by pressing the
button.
Note:
• No power is taken from the batteries while the mains adapter is connected to the instrument.
• If the mains voltage is interrupted during the measurement (e.g. by accidental removal of the mains
adapter from the mains socket), the instrument must be reset by removing the plug from its socket and
re-inserting the connections.
• Please consult a specialist dealer if you have questions relating to the mains adaptor.
appears in the display, the
appears, the device will not
23