golmar Rock Serie Manuel D'installation page 83

82
Example of cascade connected devices
Remove CN4 connector jumper from all the monitors
(see pag e 69), except fro
the coaxial cable end is located (without using
output).
Example of distribution connected devices.
Remove the end of line jumper from all the distributors
(JP1) and monitors (CN4), except from those ones
in which the coaxial cable end is located (without
using output).
If your device is equipped with just one door panel,
do not consider connections to other door panels.
If your device is equipped with more than one door panel,
connect the other door panels as shown in the picture.
IMPORTANT NOTE
When using a d.c. lock release, just 2 wires are
needed between power supply and door panel.
Refer to diagram on page 80.
FA-805
PRI SEC
+ -
230 110 0 ~ ~
Main
INSTALLATION DIAGRAMS
m the one in which
PVS-295SE
-
V V V V + A
out- out+ in+ in-
M
-
A D CV1 CV2
out in
Tekna Plus
RCTK Plus
CN4
_
V V
+
Malla A D
in out
Vca.
Lock release