golmar Rock Serie Manuel D'installation page 75

74
P
rogramming the T-740 Uno telephones.
Find the configuration switch located in the rear part of the door panel and
set number 2 to ON.
The door panel will produce a tone, indicating that it has entered program
mode. In systems with more than one door panel, this operation must be
carried out only in the main door panel of each building.
M S
Each apartment must have one master unit only; in case of parallel units configure them as slaves,
both monitors or telephones.
TELEPHONE PROGRAMMING
Lift the handset while pressing the lock release push button.
To show that the system is ready for programming, the door
panel and handset will reproduce a tone, being possible
to stablish audio communication.
Release the lock release push button.
Make a call to check that the telephone has been succesfully programmed.
Repeat these steps to program the rest of telephones.
Once the programming has been finished, set to OFF the programming
switch. If you don't, the door panel will reproduce a tone to advise that the
system is still into programming mode.
Press the door panel push button.
At this moment the door panel and
handset will reproduce a tone.
With the handset lifted:
If programming the telephone as Master,
replace the handset.
If programming it as Slave, press the door
release push button, then replace the handset.