golmar Rock Serie Manuel D'installation page 77

76
F
unction push buttons
D
escription of configuration dip switch.
The SW1 configuration dip switch is located in the top part left of the circuit,it is
accessed by opening the telephone and allow the next operation modes for the
auxiliary function push button:
"Autoswitch-on" mode: switches 1 and 2 to ON.
With the handset off the cradle, allows to stablish audio communication with the
1 2
"PA" output mode: switches 1to ON and 2 to OFF:
Regardless of the handset's position, it activates the "PA" telephone output.
1 2
"C
With the handset off the cradle, allows to call to a porter's exchange that it is
1 2
" Intercommunication
With the handset off the cradle, allows to make an intercom call between two units
1 2
IMPORTANT: Select
D
escription of programming push button.
The P3 programm push button is located in the top part left of the circuit,it is
accessed by opening the telephone. Allows to telephone enter in programming
mode with the door panel, (see programming process on page 78).
.
If the handset is on the craddle sends a panic call to the porter's
exchanges that have enabled the reception of this type of call. If not,
allows to call to the master porter's exchange. During call reception
and communication progresses allows the lock release activation.
Auxiliary function push
switch will realize one of the following functions: Autoswitch-on, "PA"
output, call to a slave porter's exchange and intercommunication.
door panel that has been configured with the autoswitch-on function. This
function is disabled if a communication is already established.
all to a slave porter's exchange
configurated as slave.
" mode: switches 1 and 2 to OFF.
of the same apartment.
the auxiliary function push button mode
TELEPHONE DESCRIPTION
button, depending on setting in the SW1 dip
" mode: switches 1 to OFF and 2 to ON.
before programming the telephone.
SW1
1 2
P3
Factory default
1 2
P3