Transporting And Storing - Ego Power+ CS1600 Manuel De L'opérateur

Reversing The Guide Bar
1. Remove the guide bar and chain from the chain saw, following the section:
"REPLACING THE BAR AND CHAIN".
2. Remove the chain from the guide
bar and turn the guide bar over
(Fig. 38). The bottom of the bar will
be on the top.
3. Replace the chain on the bar.
4. Reassemble the guide bar and chain
on the chain saw and adjust the
chain tension, following the section:
"REPLACING THE BAR AND
CHAIN" and "ADJUSTING THE CHAIN TENSION".

TRANSPORTING AND STORING

◾ ◾
Do not store or transport the chain saw when it is running. Always remove the
battery pack before storing or transporting.
◾ ◾
Always place the guide bar sheath on the guide bar and chain before storing or
transporting the chain saw. Use caution to avoid the sharp teeth of the chain.
◾ ◾
Clean the chain saw thoroughly before storing. Store the chain saw indoors, in a
dry place that is locked and/or inaccessible to children.
◾ ◾
Keep away from corrosive agents such as garden chemicals and de-icing salts.
56V LITHIUM-ION CORDLESS CHAIN SAW — CS1600
38
45