Installing The Blade - Ego Power+ LM2020SP Guide D'utilisation

Masquer les pouces Voir aussi pour LM2020SP:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

3. While wearing protective gloves, place a metal rod (e.g., a 3.5'' length screw bit)
with diameter less than 5/16'' (8mm) into the fixing hole to act as a stabilizer.
NOTICE:
If the bolt rotates with the
motor shaft when loosening the bolt, turn
the fan by hand to align the through holes
in the fan with the holes in the blade,
and place another metal rod (e.g., a 3.5''
length screw bit) with diameter less than
1/4'' (6.35mm) into the aligned holes to
act as another stabilizer (Fig. 22).
4. Use a 9/16'' (14mm) wrench to turn
the blade bolt counterclockwise to
loosen it.
5. Continue using the 9/16'' (14mm)
wrench to turn the blade bolt
counterclockwise to loosen it
completely.
6. While wearing protective gloves,
remove the bolt, outer flange and
the blade (Fig. 23).

INSTALLING THE BLADE

WARNING:
hands by wearing heavy gloves or
wrapping the cutting edges with rags
or other materials when performing any
maintenance on the mower blade.
Always remove the battery pack when
servicing or transporting the mower.
NOTICE:
To re-install or replace the blade,
be sure to replace the parts in the exact order in which they were removed (Fig. 23).
1. Mount the inner flange to the fan (Fig. 24).
56-VOLT LITHIUM-ION CORDLESS MOWER — LM2020SP/LM2020SP-FC/LM2020/LM2020-FC
Always protect your
22
Stabilizer 1
Loosen
23
Fan
Inner flange
24
Stabilizer 2
Blade
Outer flange
Bolt
35

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Lm2020sp-fcLm2020Lm2020-fc

Table des Matières