Accessories; Remote Controller Installation Procedure - Daikin BRC1E72 Manuel D'installation

2.

Accessories

The following accessories are included.
Wood screw Small screw
(φ3.5×16mm) (M4×16mm)
(2 pcs.) (2 pcs.)
3.

Remote controller installation procedure

3-1 Determine where to install the remote controller.
Make sure to follow the
3-2 If the control cable for the remote controller is to be routed
from the rear, make a hole in the wall taking into consideration
the location of the access hole in the lower case.
Lower case
Through-hole
3-3 Remove upper case.
Insert a screwdriver in the recess of lower case to remove the upper case (2 points).
Remote controller PC-board is
installed on the upper case. Take care
not to damage the PC-board with the
screwdriver.
Take care that dust or moisture does
not touch the PC-board.
4
Clamp
(1 pc.)
Safety Considerations
1-15/16
Access
hole
5/16-3/8
Screwdriver
Insert and twist the screwdriver
lightly for removal.
Operation Installation
manual manual
(1 pc.)
when determining the location.
External view of the remote controller
5/16-3/8
Align the center of the wall
hole with the center of the
access hole on the controller
lower case when planning the
installation.
NOTE
If the hole size is too large or not in the proper
location, it may be seen after the remote
controller is installed.
Wiring retainer
(1 pc.) (1 pc.)
Upper case
Lower case
English