Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
5.
Power-on
●
Check for completion of indoor/outdoor unit wiring.
●
Ensure that covers have been replaced on electrical component boxes for both indoor and outdoor
units prior to restoring power.
5-1
The following are displayed after
power-on.
Checking the connection.
Please stand by.
During above display, the
backlight will not be available.
When 1 indoor unit is
controlled by 2 remote
controllers:
Be sure to set sub remote
controller during above display.
Press and hold 4 seconds or
longer the Mode button of the
remote controller to be set.
When the display is changed from
main remote controller to sub
remote controller, the setting is
completed.
5-2
Basic screen is displayed.
NOTE
If sub remote controller is not set at power-on in the case
of one indoor unit controlled by two remote controllers,
Error Code: U5 is displayed in the connection checking
screen.
Select the sub remote controller by pressing the Mode
button of either one of the remote controllers for 4
seconds or longer.
If the basic screen is not displayed more than 2 minutes
after Sub RC display, shut off the power supply and
check the wiring.
NOTE
When selecting a different language, refer to Chapter
12
<Main remote controller>
5-
1
Off reminder Timer
Checking the connection.
Please stand by.
Main RC
Error Code U5
Checking the connection.
Please stand by.
Main RC
<Basic screen>
5-
2
Fan
Set temperature
28
Return Press the menu button
12
.
<Sub remote controller>
5-
1
Off reminder Timer
Checking the connection.
Please stand by.
Main RC
Error Code U5
Checking the connection.
Please stand by.
Main RC
Press and hold 4 seconds
or longer the Mode button
of sub remote controller
side.
°C
Off reminder Timer
Checking the connection.
Please stand by.
Sub RC
<Basic screen>
5-
2
Fan
Return Press the menu button
Language
.
(See page 21.)
Set temperature
28
°C
English
Publicité
Chapitres
Table des Matières
