Troubleshooting Tips - CONFORAMA SABA LV10C44MINI-PLIX Mode D'emploi

Syphon Connection
The waste connection must be at a height less than 1000 mm
(maximum) from the bottom of the dish. The water drain hose
should be fixed.
Start of Dishwasher
The following things should be checked before starting the dish-
washer.
1. The dishwasher is level and fixed properly
2. The inlet valve is open
GB
3. Fill hose connections are fully tightened and not leaking
4. The wires are tightly connected
5. The power is switched on
6. The inlet and drain hoses are knotted
7. All packing materials and printings should be taken out from
the dishwasher
Attention: After installation, please make sure to keep
this manual. The content of this manual is very helpful to the
users.
106

9. Troubleshooting Tips

Before Calling for Service
Review the charts on the following pages may save you from call-
ing for service.
Problem
Dishwasher doesn't start Fuse blown, or the circuit
Technical problems
water not pumped from
dishwasher
Possible Causes What to Do
Replace fuse or reset cir-
breaker acted cuit breaker. Remove any
other appliances sharing
the same circuit with the
dishwasher
Power supply is not Make sure the dishwasher
turned on is turned on and the door
is closed securely.
Make sure the power cord
is properly plugged into
the wall socket.
Water pressure is low Check that the water
supply is connected
properly and the water is
turned on.
Door of dishwasher not Make sure to close the
properly closed door properly and latch it.
Kink in drain hose Check drain hose.
Filter clogged Check the coarse filter
(see section titled « Clean-
ing The Filter»)
Kitchen sink clogged Check the kitchen sink to
make sure it is draining
well.
If the problem is the
kitchen sink not draining
,you may need a plumber
rather than a serviceman
for dishwashers
GB
107