Change The Program - CONFORAMA SABA LV10C44MINI-PLIX Mode D'emploi

per one (see the section entitled "Loading the Dishwasher").
2. Pour in the detergent (see the section entitled "Salt, Deter-
gent and Rinse Aid").
3. Insert the plug into the socket. The power supply is 220-240
VAC /50 HZ, the specification of the socket is 10A 250VAC.
Make sure that the water supply is turned on to full pressure.
4. Press the program button, the wash program will be
changed as follows direction:
ECO->Glass->90min->Rapid->Soak->Auto->lntensive-
GB
>Normal;
5. If a program is selected, the response program indicator
will light, then you can also choose the desired function,
close the door, the dishwasher will begin work after about 1
seconds.

Change the Program

Premise:
1. A cycle that is underway can only be modified if it has only
been running for a short time. Otherwise, the detergent
may have already been released, and the appliance may
have already drained the wash water. If this is the case, the
detergent dispenser must be refilled (see the section entitled
"Loading the Detergent").
2. Open the door, the machine will be in standby state, press
the program button more than 3s then you can change the
program to the desired cycle setting (see the section entitled
94
"Starting a wash cycle...").
The front indicator shows the state of dishwasher:
A. blue light with blinking: running;
B. blue light without blinking: pause;
C. no light: stand by
NOTE: If you open the door during a wash cycle, the
machine will pause. The program light will stop blinking and
the buzzer will mooing every minute unless you close the door .
After you close the door ,the machine will keep on working.
If your model has broken remember function, the machine will
go on to finish the selected program after the power cut.
Forgot to Add a Dish?
A forgotten dish can be added any time before the detergent cup
opens.
1. Open the door a little .
2. After the spray arms stop working, you can open the door
completely.
3. Add forgotten dishes.
4. Close the door.
5. The dishwasher will run again.
At the end of the Wash Cycle
When the working cycle has finished, the buzzer of the dish-
washer will sound for 8 seconds, then stop. Turn off the appliance
using the Power switch button, shut off the water supply and
GB
95