Maintenance And Repair - Eurotops 40561 Mode D'emploi

●MAINTENANCE AND REPAIR
Do not rinse the machine with water.
The cutter should be stored in a dry place when it is not in use.
Before every use of this cutter, check whether the blade is in good order and it must be repaired in time if damage has
been found.
The blade should be cleaned and lubricated in time after every use of the cutter. When the cutter is to be used for a long
time the blades should be lubricated during operations interval.
ATTENTION!
The return of the product will be impossible if it has been used or damaged due to incorrect usage.
DISPOSAL：
The packaging material is reusable. Dispose of the packaging in an environmentally friendly way by putting it in the
appropriate recyclable waste collection containers.
Dispose of the product and the batteries in view of the environment if you want to separate. The device and the
batteries must not be thrown in with domestic waste. Take them to a recycling center for used electrical and
electronic devices. For more information you can consult your local government. Remove batteries first.
Eurotops Versand GmbH
Elisabeth-Selbert-Straße 3
40764 Langenfeld, Germany
If technical support is needed, please call ...
in Germany
in Austria 01 . 230 60 43 12 or
in Switzerland 044 . 28 36 125 or
in the Netherlands 026 . 37 36 333 or
in France 0892 . 700 470** or
In Norway tkd@eurotops.de
In Sweden tkd@eurotops.de
* 14 Cents/minute via German landline, max. 42 cents/minute via mobile phone network
**34 Cents/minute via French landline
A possible return of products should be addressed to the return address stated on your invoice.
The manual only reflects the technical conditions available under printing. Any changes in technology and equipment are
reserved.
© 01.12.2017
0180 . 530 63 63* or info@eurotops.de
info@eurotops.at
info@eurotops.ch
info@eurotops.nl
info@eurotops.fr
4. Place the blade cover on the grass and hedge shear
and slide the cover in direction to the blades until it
locks noticeable.
GB