Eurotops 40561 Mode D'emploi page 37

Hint: The grass and hedge shear cannot be operated while charging process!
2. Important charging notes.
Longest life and best performance can be obtained if the battery pack is charged when the air temperature is between
65°F-75°F (18-24℃). Do not charge the battery in an air temperature below +40°F(+4.5℃), or above +105°F(+40.5℃).
This is important and will prevent serious damage to the battery.
(1).The charger and battery may become warm to touch while charging. This is a normal condition, and does not indicate
a problem.
(2). Use the charger in normal room temperatures whenever possible. To prevent overheating, do not cover the charger
and do not charge battery in direct sunlight or near heat sources.
(3). If the battery does not charge properly —— ①check current at receptacle by plugging in a lamp or other appliance.
②check to see if receptacle is connected to a light switch which turns power off when you turn out the light. ③move
charger and battery pack to a location where the surrounding air temperature is approximately 65°F-75°F(18-24℃). ④if
charging problems persist, take or send the tool and the charger to your local service center.
(4).The battery should be recharged when it fails to produce sufficient power on jobs which were easily done previously.
DO NOT CONTINUE to use under these conditions. Follow the charging procedure.
(5).Under certain conditions, with the charger plugged in to the power supply, the exposed charging contacts inside the
charger can be shorted by foreign material. Foreign materials of a conductive nature such as, but no limited to, steel
wool, aluminum foil, or any buildup of metallic particles should be kept away from charger cavities. Always unplug the
charger from the power supply when there is no battery pack in the cavity. Unplug charger before attempting to clean.
(6). Do not immerse charger in water or any other liquid.
(7). WARNING: don't allow any liquid to get inside charger. Electric shock may result. To facilitate the cooling of the
battery pack after use, avoid placing the charger or tool in a warm environment such as in a metal shed, or an
uninsulated trailer.
●CHANGE THE BLADES
Important! DO NOT operate the switch before dismantling or fitting the blades. Risk of injury!
1. Turn the grass and hedge shear upside down and
press the clip of the blade cover (A) (step 1)
downwards. Hold the blade cover firmly and pull
the cover forwards to remove from the grass and
hedge shear (step 2).
2. Either insert the blades for scrubs/hedge in the
grass and hedge shear or the grass blades. The
blades fit only in one position into place.
3. Lightly tilt the blades and insert into the grass and
hedge shear. Make sure the blades fit under both
locking pins. Press the blades down.
GB