Ribimex Ribiland PRTH509A Manuel D'instructions Et D'utilisation page 19

Ensure that the voltage of the mains power supply matches the operating voltage indicated on the
tool's rating plate.
- Connect the power plug to the coupling of an appropriate extension cord.
- Form a loop with the extension cord, push it through the opening in the rear handle and hook over
the cable holder (8) (see Fig.2).
4.3- Starting the machine
- Switching on: press the on/off switch (4) of the front handle and the switch (5) of the rear handle
with both hands at the same time.
- Switching off: Release any one of the switches (4) or (5).
- The blade brake makes the blades stop immediately within 0.5s
Warning! The cutting blades continue to move for a few seconds after the hedge trimmer is
switched off. Wait until the cutting blades come to a complete standstill before placing the machine
down
Caution! Do not touch the moving blades.
4.4- Rotating handle adjustment
Press on unlock button (9) and then rotate handle clockwise or anti-clockwise.
It is possible to adjust at 45 or at 90.
V. OPERATION
5.1- Intended use
- The product is intended for outdoor domestic use in private gardens.
- The product is intended for cutting hedges, shrubs within the limits of its characteristics.
- This tool may not be used to do other things outside of the described scope in this manual.
- Do not use the machine for unsuitable purposes (for ex. for cutting wood ...)
- The tool is not intended for professional or industrial use (for ex.: in public parks...).
5.2- Operation
Before any operation:
-- always visually inspect that the product does not show signs of use or damage
-- check that the screws, bolts and nuts are well tightened.
Replace any used or damaged part, and tighten firmly the screws, bolts and nuts when needed.
PRTH509A / RHK514856
(only available on PRTH610A /
PRTH610A / RHK514866
Fig.2
Fig.3
RHK514866)
Page 19 / 31