Installation Procedures; Installation Checklist - Manitowoc S160 Manuel D'installation, D'utilisation Et D'entretien

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Section 2

Installation Procedures

!
Do not attempt to move a dispenser without first
removing the ice machine. The combination can be
unstable and could tip, causing serious injury.
1. Review the Pre-Installation Checklist; then make
sure all utility and space requirements are present at
the installation site.
2. Remove the carton top from the dispenser.
3. Remove the legs and other accessories from inside
the dispenser bin.
4. Remove the carton from the sides of the dispenser.
5. Remove the dispenser from the shipping pallet.
6. Flatten the shipping carton.
7. Lay the dispenser on its back; on the carton.
8. Thread the legs into the bottom of the dispenser.
9. Set the dispenser upright.
10. Place the dispenser in the desired location.
11. Make sure the dispenser bin top is level. A level bin
is important for proper operation of the ice machine.
12. Place the ice machine on top of the dispenser at this
time.
13. Connect the drain of the dispenser to the floor drain.
14. Follow local plumbing codes for drain installation.
15. If the dispenser has a water valve, connect your
water line to the water connection at the back of the
dispenser.
16. Test all drain and water lines for leaks.
17. Plug the dispenser into the proper electrical outlet.
18. Clean and sanitize all equipment. Follow cleaning
and sanitizing instructions in this manual.
19. Adjust the ice machine according to the instructions
provided with the ice machine.
20. Install ice baffle inside the ice maker compartment.
Follow installation instructions supplied with ice
baffle.
21. Install foam gasket on the bottom of the front panel.
22. Fill the dispenser bin one quarter full of ice or start
the ice machine, allowing the ice machine to drop at
least three complete batches of ice.
23. Test the ice dispensing action of the dispenser.
Part Number 000007646 11/10
Warning

Installation Checklist

Dispenser and ice machine are level?
Drains are vented?
Dispenser does not sit in direct sunlight?
Dispenser does not sit in direct airflow from a
heating duct?
Bin and ice machine drains are separate?
Ice dispensed properly?
Dispenser is accessible for servicing?
The warranty card was returned?
Ice Machine ice thickness control is properly
set?
Owner was instructed on the operation of the
dispenser?
Owner knows how to clean and sanitize the
dispenser?
Owner knows how often to clean and sanitize
the dispenser?
Owner has your telephone number to call for
follow-up service on the dispenser?
You have placed one of your service stickers on
the dispenser for follow-up service?
Installation Instructions
7

Publicité

Chapitres

Table des Matières
loading

Ce manuel est également adapté pour:

S190S290S300

Table des Matières