Inserting Batteries; Using The Remote Control - Nordmende 43A Mode D'emploi

3.4.1 Connecting aerial/satellite signal
>
Connect the digital cable connection (DVB-C) or digital terrestrial television (DVB-T2)
reception cable to the AERIAL/CABLE socket on the digital TV set.
>
Connect the digital satellite system (DVB-S/S2) reception cable to the SAT 1 socket on the
digital TV set.

3.5 Inserting batteries

1. To remove the battery compartment cover, press the marked area on the cover and then
pull down on the cover and lift it up.
2. Insert the batteries according to the markings (+) and (-) in the battery compartment.
3. Replace the battery cover in reverse order.
>
Only use the specified AAA batteries.
>
Do not mix old and new batteries. Otherwise, the batteries may break or leak, which in
turn may cause fire or injury.
>
Insert the batteries according to the markings (+) and (-). Improper installation may cause
the batteries to leak, which in turn may cause fire or injury.
>
Dispose of the batteries according to the local laws and regulations.
>
Keep the batteries away from children or pets.
>
Remove the batteries if you will not be using the remote control for a long time.

3.5.1 Using the remote control

Point the remote control sensor directly at the bottom right corner of the TV set.
The operating range of the remote control is approx. 10 metres with an angle of approx. 30 degrees.
Remove any obstacles between the remote control and the sensor.
CAUTION
Page 33