Vacuum Process - Waeco ASC 6100G Manuel D'utilisation

2.
In the basic menu use the cursor keys
Short selection
Free selection
Other selections
ENTER-OK
3. Press ENTER to confirm.
4. Enter the vehicle data and press ENTER to confirm.
13.8.1 Recovery phase
1. Enter the preferred settings and press ENTER to confirm.
Rec/Recycling
phase?
ENTER-OK STOP-EXIT
2.
If Rec/Recycling phase has been selected, enter the preferred waiting time for the pressure increase
(standard is 1 min.) in the following menu and press ENTER to confirm, otherwise continue with chapter

Vacuum process

on page 21.
Pressure increase
Test time
ENTER-OK STOP-EXIT
Note The waiting time ensures that any residual refrigerant vaporises and can then be extracted.
The vaporising residual refrigerant triggers an increase in pressure.
13.8.2 Vacuum process
1. Enter the preferred settings and press ENTER to confirm.
Vacuum phase
ENTER-OK STOP-EXIT
2. If Vacuum phase has been selected, enter the preferred vacuum time (standard is 20 min), otherwise con-
tinue with chapter Filling process
3.
Use the cursor key
4. Press ENTER to confirm both settings.
Vacuum time
Vacuum test time
ENTER-OK STOP-EXIT
The air conditioning system is drained completely by the vacuum pump. This is used to remove any remain-
ing carrier gases or moisture and to prepare the air conditioning system for the filling process. Any residual
refrigerant extracted which is still bonded in the refrigerant oil is collected by the A/C Service unit and recy-
cled.
13.8.3 Filling process
1. Enter the preferred settings and press ENTER to confirm.
Filling phase?
ENTER-OK STOP-EXIT
2. If Filling phase has been selected, enter the required value, otherwise continue with chapter
connections on page 22.
or to select Free selection.
Yes
No
min.
Yes
No
on page 21.
to enter the vacuum phase time.
min. 20
min.
Yes
No
1
4
English
Selecting
21