Dynamic Ip Address Assignment - Tripp-Lite PDUMVR20NET Manuel Du Propriétaire

Installation

Dynamic IP Address Assignment

3-1
Connect Network Interface to
Network: Connect a standard Ethernet
patch cable to your network using the
RJ45 Ethernet port on the PDU's Network
Interface.
Note: This port does not support PoE (Power
over Ethernet) applications.
The interface will attempt to obtain an IP address via DHCP . This may take as long as
several minutes, depending on your network environment.
3-2
Determine IP Address: To identify the IP address assigned to the Network Interface,
contact your network administrator and provide the MAC address of the Network Interface.
You can also determine the IP address locally at the card.
Start a terminal emulation program, such as Tera Term Pro. Configure the COM port
intended for use by following these settings: 115.2 Kbps, 8, NONE, 1. Using the included
RJ45 to DB9 cable (part number 73-1243), connect your PC to the PDU's CONFIG port.
When the login prompt appears, login as localadmin / localadmin. When the Menu
appears, navigate to "3- Network Configuration", then to "1- IP Configuration". The
assigned IP address will be displayed. After you have determined the IP address, proceed
to the Test Network Connection section.
Note: You may wish to request a long-term lease period for the IP address, depending on your
application.
Note: PowerAlert Device Manager and the PDU's Network Interface support both IPv4 and IPv6. The
card is set up by default to receive a DHCP address for IPv4, IPv6 or both. Receiving both addresses
allows connection to the card via either the IPv4 or IPv6 address.
Static IP Address Assignment /
Terminal Menu Configuration Settings
4-1
Determine IP Information: The Network Interface can support a single static IPv4
address (requires setting the IP address, subnet mask and gateway) and/or a single static
IPv6 address. In addition, the Network Interface can support a single static IPv4 or an IPv6
DNS address that is required to be entered.
4-2
Configure Terminal Emulation Program: Set your terminal emulation program to use the
COM port with its corresponding USB port.
16-10-211-933668.indb 5
5
12/22/2016 11:36:15 AM