Status Led - Lindy 39374 Manuel Utilisateur

User Manual
Overview
Transmitter
Front Panel:
USB QC
USB
▲USB LED

▲STATUS LED

EDID
Rear Panel:
RS-232
IR OUT
IR IN
TOSLINK IN
HOST
USB 1
MINI USB
USB 2
GROUND
POWER
EXTEND / SERVICE Extend / Service switch assists in serial control. Please see the "Installation &
CAT OUT
HDMI 1
AUDIO IN
HDMI 2
MIC OUT
Connect USB devices. This port also supports Quick Charge.
Connect USB devices.
The USB LED will emit a solid orange light when there are no USB devices
detected. When USB devices are detected, the LED will intermittently flash "x"
times depending on how many devices are detected (between 1 and 4).
The status LED will emit a solid green light when there is a successful link
between the transmitter and receiver. It will emit a solid red light when there is
no link detected.
The EDID button is used to copy the EDID of each display from each source.
Please see the "Installation & Operation" section of this manual for instruction
on copying EDID's.
Connect to a PC for serial control.
Connect an IR transmitter.
Connect an IR receiver.
Connect a TOSLINK (optical) cable from a PC to pass-through digital audio.
Please see the "Installation & Operation" section of this manual for detail.
Connect a USB device. Please note: When the "Host" Switch is set to "Host"
this port will only provide power to the USB device.
Connect to a PC or Laptop.
Connect a USB device.
Ground connection
Connect an included 12VDC 1.5A multi-country power supply.
Operation" section of this manual for full detail.
Connect up to a 100m (328.08ft) Cat.6 (or higher) cable.
Connect an HDMI cable from a PC.
Connect a 3.5mm stereo audio cable from a PC to pass-through analogue audio.
Connect an HDMI cable from a PC.
Connect a 3.5mm audio cable to pass-through a microphone input from the
receiver.
English