Lindy 39374 Manuel Utilisateur page 7

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

User Manual
Receiver
Front Panel:
USB QC
USB
▲USB LED
▲STATUS LED
EDID
Rear Panel:
RS-232
IR IN
IR OUT
TOSLINK OUT
HOST
USB 1
MINI USB
USB 2
GROUND
POWER
EXTEND / SERVICE Extend / Service switch assists in serial control. Please see the "Installation &
CAT IN
HDMI 1
AUDIO OUT
HDMI 2
MIC IN
Connect USB devices. This port also supports Quick Charge.
Connect USB devices.
The USB LED will emit a solid orange light when there are no USB devices
detected. When USB devices are detected, the LED will intermittently flash "x"
times depending on how many devices are detected (between 1 and 4).
The Status LED shows current links between the transmitter and receiver.
Please see the "Installation & Operation" section of the manual for full details.
The EDID button is used to copy the EDID of each display from each source.
Please see the "Installation & Operation" section of this manual for instruction
on copying EDID's.
Connect to a serial control device.
Connect an IR receiver.
Connect an IR transmitter.
Connect a TOSLINK (optical) cable to an amplifier or active speaker system.
Please see the "Installation & Operation" section of this manual for detail.
Connect a USB device. Please note: When the "Host" Switch is set to "Host"
this port will only provide power to the USB device.
Connect to a PC or Laptop.
Connect a USB device.
Ground connection
Connect an included 12VDC 1.5A multi-country power supply.
Operation" section of this manual for full detail.
Connect up to a 100m (328.08ft) Cat.6 (or higher) cable to establish a link
between the transmitter and receiver.
Connect an HDMI cable to a display or projector
Connect a 3.5mm stereo audio cable to an amplifier or speakers.
Connect an HDMI cable to a display or projector.
Connect a 3.5m audio cable to pass-through a microphone input from the
receiver.
English

Publicité

Table des Matières
loading

Table des Matières