Error Messages - WEBTEC HPM4000 Mode D'emploi

error messages

5. Error messages
Display Description
ERROR 1 Internal device error
ERROR 2 Memory error
Error when saving to the USB flash drive
USB ERROR
The USB flash drive is full
USB FULL ERROR
The firmware update has failed. This occurs when
FIRMWARE
the transfer of a new firmware from the USB flash
ERROR
drive failed.
CAN ERROR CAN initialisation failed. Unknown CAN sensor, or
more than three CAN sensors connected
42
Solution
Confirm by clicking <OK>. If this occurs frequently,
please return the unit for repair.
Confirm by clicking <OK>. If this occurs frequently,
please return the unit for repair.
USB flash drive is full, defective or not compatible.
Please use only USB flash drives that conform to the
Technical Specifications (see page 46).
Delete files on the USB flash drive or use a new one
Confirm by clicking <OK>. If this occurs frequently,
please return the unit for repair.
Please make sure you are only using Webtec CAN
sensors and connecting no more than three sensors.
V1.0/02/12