Step 3: Connect Coax Cables To Booster - weBoost DRIVE REACH Guide D'installation

______
Step 3: Connect Coax Cables
To Booster
Connect the cable from the Mini-Mag Mount Antenna to the
port labeled "Outside Antenna" on the Drive Reach booster.
NOTE: Bracket can be used to fasten booster in a specific location if
desired. The Velcro® strip on the bottom of the bracket can also be used to
keep booster from sliding around.
Drive Reach
from Outside Antenna
bracket
Connect the cable from the 4G In-Vehicle Antenna to the port
labeled "Inside Antenna" on the booster.
from Inside Antenna
5
DRIVE REACH VEHICLE SIGNAL BOOSTER