Black & Decker CM1836 Manuel D'instructions page 7

ASSEMBLY
Tools required for assembly:
Adjustable or 1/2 inch (13mm) wrench
HANDLE ASSEMBLY - (FIGURE B)
1. Insert the lower handle tube and align the round holes in the lower handle section (B1) with the two threaded studs (B2) in the side wall of the
deck.
2. Push the handle section onto the studs fully. B
3. Thread on two lock nuts (B3) and tighten with a 1/2 inch (13mm) wrench. Repeat for other side.
4. Slide the one piece upper handle into one of the 3 adjustment positions (C1), aligning the holes in the upper and lower handles.
NOTE: Adjust the handle position at this time to suit your height preference. Taller users may want the handle assembled as shown in
figure C while shorter users may
want to adjust the upper handle
to one of the two remaining
height adjustment positions.
5. Insert the carriage bolt (C2) until
the head of the bolt is fully seated
against the handle.
6. Align the cord retainer (C3) with
the carriage bolt. Install the knob
(C4), tightening securely. The
knobs should always be on the
outside of the handles to avoid
interference with the rear door and
grass bag. Insert carriage bolt and
install knob for other side.
ASSEMBLING THE GRASS CATCHER (FIGURES D1, D2, D3,
D4)
1. Before starting to assemble the grass bag to the frame, check that the grass bag and frame are similar to figure D1.
2. Slide the grass bag onto the frame as shown in figure D2.
3. Assemble the top clips to the frame as shown in figure D3, then assemble the two side clips and the bottom clip last.
4. Completely assembled grass catcher is shown in figure D4.
GRASSBAG
D1
FRAME
C
7
3
1
2
D2