Electrical Safety - Black & Decker BEW210 Mode D'emploi

Masquer les pouces

Table Des Matières

Table des Matières

Les langues disponibles

ENGLISH

Hold the power tool by insulated gripping surfaces,

because the sanding surface may contact

its own cord. Cutting a "live" wire may make exposed

metal parts of the power tool "live" and could give the

operator an electric shock.

Use clamps or another practical way to secure and

support the workpiece to a stable platform. Holding the

work by hand or against your body leaves it unstable and

may lead to loss of control.

Warning! Contact with or inhalation of dusts arising

from sanding applications may endanger the health

of the operator and possible bystanders. Wear a dust

mask specifically designed for protection against dust and

fumes and ensure that persons within or entering the work

area are also protected.

Thoroughly remove all dust after sanding.

Take special care when sanding paint which is pos-

sibly lead based or when sanding some woods and

metal which may produce toxic dust:

Do not let children or pregnant women enter the

work area.

Do not eat, drink or smoke in the work area.

Dispose of dust particles and any other debris

safely.

The intended use is described in this instruction

manual.

The use of any accessory or attachment or performance

of any operation with this tool other than those recom-

mended in this instruction manual may present a risk of

personal injury and/or damage to property.

Safety of others

This appliance is not intended for use by persons (includ-

ing children) with reduced physical, sensory or mental

capabilities, or lack of experience and knowledge, unless

they have been given supervision or instruction concern-

ing use of the appliance by a person responsible for their

safety.

Children should be supervised to ensure that they do not

play with the appliance.

Residual risks.

Additional residual risks may arise when using the tool which

may not be included in the enclosed safety warnings. These

risks can arise from misuse, prolonged use etc.

Even with the application of the relevant safety regulations

and the implementation of safety devices, certain residual

risks can not be avoided. These include:

Injuries caused by touching any rotating/moving parts.

Injuries caused when changing any parts, blades or ac-

cessories.

(Original instructions)

Injuries caused by prolonged use of a tool. When using

any tool for prolonged periods ensure you take regular

breaks.

Impairment of hearing.

Health hazards caused by breathing dust developed when

using your tool (example:- working with wood, especially

oak, beech and MDF.)

Vibration

The declared vibration emission values stated in the technical

data and the declaration of conformity have been measured in

accordance with a standard test method provided by EN62841

and may be used for comparing one tool with another. The

declared vibration emission value may also be used in a

preliminary assessment of exposure.

Warning! The vibration emission value during actual use of

the power tool can differ from the declared value depending

on the ways in which the tool is used. The vibration level may

increase above the level stated.

When assessing vibration exposure to determine safety

measures required by 2002/44/EC to protect persons regularly

using power tools in employment, an estimation of vibration

exposure should consider, the actual conditions of use and the

way the tool is used, including taking account of all parts of the

operating cycle such as the times when the tool is switched off

and when it is running idle in addition to the trigger time.

Labels on tool

The following symbols are shown on the tool, along with the

date code:

Warning! To reduce the risk of injury, the user

must read the instruction manual.