Axor ShowerSelect Round 36722 1 Série Mode D'emploi / Instructions De Montage page 27

T R O U B L E S H O O T I N G
P RO B L EM
Insufficient water
Crossflow, hot water being forced into
cold water pipe, or vice versa, when
mixer is closed
Spout temperature does not corre-
spond with temperature set
Temperature regulation not possible
Safety stop button not operating
Shutoff valve stiff
Shower or spout dripping
Pushbutton cannot be actuated or is
without function
Pushbutton is jammed or stiff
Pushbutton does not snap in
M AI N TE N A N C E
⁄ Inspect the check valves at least once per year.
Replace the check valves if necessary.
⁄ Should the volume of water decrease over time,
inspect and clean the filters on the thermostatic
cartridge. After reassembly, set the high temperature
limit stop and justify the handle.
⁄ To prolong the life of the themostatic cartridge, regu-
larly run it through its full range of temperatures.
POS S IB L E C AU SE
Supply pressure inadequate
Regulator filter dirty
Handshower filter seal dirty
Check valves dirty or worn
Thermostat has not been adjusted
Hot water temperature too low
Thermostatic cartridge dirty or worn
For new installations: rough valve
incorrectly connected (should be: cold
right, hot left)
Spring dirty or worn
Button calcified
Select shutoff valve DN9 dirty or worn
Select shutoff valve DN9 dirty or worn
Safety guard of on-off valve has not been
removed
O-ring needs to be lubricated
Select Adapter trimmed incorrectly
SO LUTION
Check water pressure (If a pump has
been installed check to see if the pump
is working).
Clean filters
Clean filter seal between handshower
and hose
Clean check valves, replace if necessary
Justify the handle
Increase hot water temperature
Clean thermostatic cartridge, replace if
necessary
Rotate function block 180°or correct the
plumbing
Clean spring and/or button, replace if
necessary
Replace Select shutoff valve DN9
Replace Select shutoff valve DN9
Remove safety guard from isolating valve
Lightly lubricate the o-ring using white
plumbers' grease
Trim and mount Select Adapter accord-
ing to Fig. 7 (see page 8)
Press the pushbutton into the escutcheon,
then mount the escutcheon.
27