Samsung WB09H7 Serie Manuel D'utilisation page 18

5. Make sure the drain hose is connected as shown.
CAUTION: Once you have tightened the screw on the clamper, do not loosen it. Otherwise,
water may leak while the washer operates.
Position the drain hose
The end of the drain hose can be positioned in three ways:
Over the edge of a wash basin
Secure the guide to the side of the basin wall with a hook or
to the tap with a piece of string to prevent the drain hose from
moving.
In a standpipe or laundry tub
The standpipe must be no shorter than 39 in (99 cm) and no
longer than 96 in (245 cm).
• Make sure that the connection between the drain hose
and the standpipe is not airtight.
• Connect the hose guide within 4 in (10 cm) of the end
of the drain hose. If the drain hose extends more than
4 in (10 cm) beyond the end of the hose guide, mold
or microorganisms could spread to the inside of the
washer.
• The Drain Hose can be installed up to 96 in (245 cm) above the floor, maximum, but the
draining capability can be reduced at this height. It can cause the washer to have an
odor because of water remaining in the drain system.
• If the drain hose is installed below 39" (99cm), the syphon effect can cause water to flow
back into the washer during a cycle. If this occurs, the washer displays an "4E" error.
Untitled-2 18
96˝ Max 96˝ Max
39˝ Min 39˝ Min
39˝ Min
English - 18
Laundry tub
Hose retainer
Tie strap
Standpipe
Hose retainer
Tie strap
2014-05-26 10:51:13