i-tec USB 3.0 SATA HDD Mode D'emploi page 6

i-tec USB 3.0 SATA HDD Docking Station
SOFTWARE INSTALATION
The device is supported by the operating system and it is not necessary to install any
drivers. Just make sure that you have installed the most recent drivers for the USB
3.0 controller in your computer.
Note: If you insert two HDDs into the docking station at the same time, you can work
with them in a standard way as with other HDDs in the OS and you can also transfer
data between them.
HDD CLONING
1) Before cloning, disconnect the docking station from the notebook / PC.
2) The docking station must be turned ON and the power adaptor must be
connected.
3) Insert the source HDD (Source HDD1) into the docking station – the red LED HDD1
will go ON.
4) Insert the target HDD (Target HDD2) into the docking station – it must have the
same or higher capacity as the source HDD1 – the red LED HDD2 will go ON.
5) After that you can use the docking station for simple HDD backup / cloning. Start
the backup by double-clicking on the "CLONE" button (next to HDD2).
6) This will start data transfer from HDD1 to HDD2. The process is indicated by blue
LEDs 25% / 50% / 75% / 100%. When completed, all 4 blue LEDs will go ON.
EN
05