Menu Parameters - Samson SYNTH SEVEN Manuel Du Propriétaire

Menu Parameters

Group & Channel
Group Manually adjusts the operating Group
Channel Manually adjusts the channel with the selected Group
Scans the current selected group channels and selects the cleanest
Group Scan
signal to use for optimal performance
Sends the group and channel information to the UH7 and UB7
IR Set
transmitters via the infrared set.
Frequency Select
Frequency Manually adjust the operating frequency of the UR7 receiver.
Scans the entire frequency band of the UR7 receiver and selects the
Scan Spectrum
cleanest signal to use for optimal performance.
Sends the operating frequency information to the UH7 and UB7
IR Set
transmitters via the infrared set.
Audio Setup
Sets the level of the audio signal being output through both the
Audio Level
balanced and unbalanced output jacks on the rear panel.
Enables a high pass filter on the audio output. This is useful when
using the receiver with a handheld microphone to reduce lower
HPF
frequencies that you do not want the microphone to pick up. It is
useful for removing stage rumble.
Advanced Setup
Squelch Adjusts the squelch threshold
Enables or disables the Tone Key. This is useful when setting up the
Tone Key
system to. During normal operation the Tone Key should be enabled.
Contrast
Adjusts the contrast of the receiver display.
Lock Locks the controls of the receiver.
12
Group & Channel
A
Group
01
Channel
Group Scan
IR Set
Back
Frequency Select
632.000
MHz
Scan Spectrum
IR Set
Back
Audio Setup
01
Audio Level
HPF OFF
Back
Advanced Setup
Squelch LOW
ON
Tone Key
01
Contrast
Lock ON
Back