8. AUTOMATIC
WASHING/DRYING
CYCLE
You cannot exceed the maximum
dryable load of laundry indicated in
the programme table, otherwise the
laundry will not be dried satisfactory.
- Washing
l
Open the drawer and put in the correct
amount of detergent.
l
Refer to the list of washing programmes
for the fabrics to be washed (e.g. very
dirty cotton) and turn the selector knob to
the required programme.
l
Adjust
the
wash
necessary.
l
Press the option buttons (if required).
l
Check that the tap is turned on and that
the
discharge
correctly.
- Drying
l
Select the degree of dryness that you
require choosing one of 3 automatic
programmes:
Extra dry programme (suitable for
towels, bathrobes and bulky loads).
Iron dry programme (that leaves the
laundry ready for ironing).
Cupboard
items that will be put away without
ironing).
l
If you wish to select a timed drying
programme,
press
SELECTION" button until the required
time indicator lights up.
l
Press the START/PAUSE button.
temperature
hose
is
positioned
dry
programme
the
"DRYING
l
The programme selector remains in the
same stationery position throughout the
cycle until it ends.
l
At the end of the wash phase the display
will show the drying time remaining.
l
The washer dryer will then complete the
entire drying programme.
l
The drying programme indicator will be
on, until the cool down phase begins and
the corresponding indicator is on.
l
When the programme is finished the word
"End" will appear on the display. After 5
minutes the appliance will go into
standby mode (on certain models, the
display will show two lines).
if
l
After the programme has finished please
wait for about 2 minutes until the DOOR
LOCKED indicator has gone out before
opening the door.
l
Switch off the machine by turning the
programme selector to the OFF position.
l
Open the door and remove the laundry.
l
Turn off the tap.
CANCELLING THE DRYING PROGRAMME
l
To cancel the drying programme, press
and hold the DRYING SELECTION
button for about 3 seconds.
(for
WARNING:
After cancelling the drying programme,
the cool down phase will begin and you
must wait for about 10/20 minutes
before opening the door.
26