Leuze ODS 9 Mode D'emploi page 19

Safety
This sensor was developed, manufactured and tested in line with the applicable
safety standards. It corresponds to the state of the art.
Intended use
The ODS9 is an optical distance sensor which allows distance measurements of
up to 650 mm.
Areas of application
The ODS9 is designed for the following areas of application:
– Distance measurement
– Contour determination
– Thickness measurement
– Positioning
– Filling level measurement
– Diameter determination
CAUTION
Observe intended use!
The protection of personnel and the device cannot be guaranteed if the
device is operated in a manner not complying with its intended use.
Ä
Only operate the device in accordance with its intended use.
Ä
Leuze electronic GmbH + Co. KG is not liable for damages caused
by improper use.
Ä
Read this supplement and the operating instructions for the device
before commissioning the device. Knowledge of these documents
is required in order to use the equipment for its intended purpose.
NOTICE
Download operating instructions from the Internet
Ä
Call up the Leuze home page: www.leuze.com.
Ä
Enter the type designation or part number of the device as the
search term.
Ä
The operating instructions can be found on the product page for
the device under the Downloads tab.
NOTICE
Comply with conditions and regulations!
Ä
Observe the locally applicable legal regulations and the rules of
the employer's liability insurance association.
EN
19