Preparing The Appliance - Krups ESPRESSERIA AUTOMATIC EA 80 Série Utilisation Et Entretien

Masquer les pouces Voir aussi pour ESPRESSERIA AUTOMATIC EA 80 Série:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 78
Programme settings when using the filter cartridge
If you use a filter cartridge, in the "Filter"
settings menu, answer the question with
"Yes" or "OK". This programme can also
be accessed by going to "Product Info"
then selecting "Filter" and "Installer" or
by going to "Maintenance / Filter / Exit".
Place a recipient with a capacity of
around 0.5 litres under the steam nozzle

3.2 Preparing the appliance

Before switching on the appliance, carry
out the following steps.
!
Caution :
Water tank (10) : Do not
fill the tank with hot water, mineral water,
milk or any other liquid as this could da-
mage the appliance.
Coffee bean holder (15) : Do not put
ground coffee or water into the coffee
bean holder as the grinder could be da-
Remove the water tank (10) and fill it with
cold water.
i
Tip : You can fill the tank without removing it:
open the lid and pour in the water using a sui-
table recipient.
Fit it and close the lid.
Open the lid (12) of the coffee bean hol-
der (15) and fill it with coffee beans (max.
275 g).
Close the lid of the coffee bean holder.
Use and maintenance / SERIE EA 80xx
KRUPS Espresseria Automatic
as the programme fills the water filter car-
tridge and a greater quantity of water is
therefore dispensed from the steam noz-
zle. 1 message on the screen then invites
you to set the date that the filter is fitted
so that the programme can advise when
to change the filter (in 2 months or after
50 litres of water).
maged. Ensure that no foreign particles
(e.g. small stones in the coffee beans)
get into the holder as they could damage
the grinder (not covered by the guaran-
tee!).
Drip tray (23) : To avoid the risk of burns
due to hot water splashing, check that
the drip tray is fitted correctly !
!
Important : Respect the maximum
filling level (reference "Max") of the
water tank.
!
Note : If, when the appliance is switched
on, the water tank is missing or does not
contain enough water (under the refe-
rence "Calc"), the message "Fill the tank"
will be displayed and it will not be possi-
ble to prepare espresso or coffee.
13

Publicité

Table des Matières
loading

Table des Matières