Cub Cadet 19A30030100 Manuel De L'utilisateur page 8

3. Secure the bag support assembly to the
mounting assembly using a carriage bolt
(710-0276) and wing knob (720-04122) from
hardware pack 689-00600. See Figure 4-7.
Figure 4-7
4. Install the hanger assembly onto the upright
support bracket using a carriage bolt
(710-0276) and wing knob (720-04122) from
hardware pack 689-00600. See Figure 4-8.
Figure 4-8
Assembling Remaining Bagger
Components
With the mounting brackets assembled and in place
on the tractor, follow these steps to assemble the
remaining bagger components.
1. Tilt the front of the upper chute support
slightly forward and snap the front side latch
to the rail, as shown in (1) of Figure 4-9. Slide
clip behind tab.
1
Figure 4-9
8 I
nstallatIon
2. Snap the upper chute support in place by first
clipping the side portion onto the bagger
support rail with the edge of the snap feature
aligned with the red line, see (2) in Figure 4-9.
3. Slide the left side grass catcher cover over the
upper chute support and the bag support
assembly. Carefully latch the two tabs in place
into the front of the upper chute support, see
1 in Figure 4-10. Fit the snaps onto the left side
bagger rail support. See 2 in Figure 4-10.
1
2
Figure 4-10
4. If not already installed, apply seals (720-
05151A) and (720-05152B) to the underside of
the upper grass catcher cover (731-12348D) as
shown below. See Figure 4-11.
Figure 4-11
5. From the front of the assembly, line up the
tabs on the upper grass catcher cover with
the tabs at the front of the upper chute
support. Slide the hinge pin through the
slots beginning at the right side upper chute
support of the mounting tabs, as in Figure
4-12. Push the pin all the way in until it reaches
the end-stop.
2
Figure 4-12
NOTE: The pin clips into place and is secured
by a tab on each side of the bagger cover.
Swing the upper grass catcher cover down to
close the attachment. pushing in on the rear
right-side and rear left-side tabs and lock them
into place under the notches on each side.
Ensure a secure, snug fit. See Figure 4-13.
Figure 4-13
6. Open the bagger cover by pushing in on the
tabs and lifting the upper grass catcher cover
See Figure 4-14.
Figure 4-14