Panasonic S-36PU1E5 Instructions D'installation page 22

(4) Setting the Flap Separately (When setting the CZ-RTC2)
1) The 4-air outlet flap can be adjusted separately during
operation. When not adjusted separately, all flaps
operate in the same manner.
Air discharge
port
(adjustment for up-down airflow direction)
<Procedure>
Stop the system before performing these steps.
1 Press and hold the
simultaneously for 4 seconds or longer.
2 If group control is in effect, press the
and select the address (unit No.) of the indoor unit
to set. At this time, the fan at the indoor unit begins
operating.
3 "
," unit No. "
group control), item code "
" " are displayed blinking on the remote
controller LCD display.
4 Designate the item code "
Temperature Setting
=91
Flap
, and buttons
" (or " " in the case of
," and settings data
" by adjusting the
/ buttons.
Electrical component box
=90
=93
=92
5 Press the timer time
desired setting data.
Flap position
* Setting data "
Setting data
button
When the flap position is set to
is in the cooling or dry mode, the flap position is
moved to
Fig. 7-11)
The flap swings during the operation under "Setting
the Flap Separately".
At this time, the unselected flaps are moved to the
position
6 Press the
(The display stops blinking and remains lit, and
setting is completed.)
If you wish to change the selected indoor unit,
follow the step 2.
7 Press the
controller display.
7
22
/
1
2
3
4
5
" (refer to Fig. 7-11)
Flap position during operation
Without separate setting
Swing
Move to position
Move to position
Move to position
Move to position
Move to position
and the operation is started. (refer to
3
NOTE
. (refer to Fig. 7-11)
1
button.
button to return to normal remote
3
1
6 5
buttons to select the
Fig. 7-11
and stay
1
2 and stay
and stay
3
4 and stay
and stay
5
or and the unit
4 5
2
4