Inflate The Wheels; Use; Turn Doc Pro On; Do Not Stand On The Board During This - Nilox DOC PRO Mode D'emploi

Inflate the wheels

For safety reasons, the wheels are not inflated in the
package. Please use the supplied instruments to inflate
the wheels to about 2.5 atm before driving DOC PRO.
Once assembled, make sure that:
-
The handlebar and steering column are joined and no movement or noise is perceptible.
-
The ON/OFF switch works correctly.
-
The height adjustment lever is closed. If this is not the case, the handlebar rod could move,
causing you to lose control of the vehicle.
-
The rear wheel break pedal can move freely without obstacles.
U
SE

TURN DOC PRO ON

Do not stand on the board during this

operation.

Enable or disable the speed switch

To enable: press the switch.
To disable: press the switch again.
IMPORTANT: CHECK LOCAL LAWS ON ANY
SPEED LIMITS.

Stand on the board

Place one foot on the board, avoid starting the rear wheel
brake during this operation.

Start driving DOC PRO

Start with one foot on the ground, push DOC PRO forward
while simultaneously accelerating.

Slowing and braking

Release the accelerator to slow.
To immediately brake DOC PRO, place your foot on the rear
wheel brake pedal.
EN
7