Cleaning; Maintenance And Repairs; Removing The Front Wheel - Nilox DOC PRO Mode D'emploi

•
Do not charge the battery in very humid areas.
•
Do not use the charger if the cables or connectors are damaged.
C
LEANING
•
Always close the power port before cleaning.
•
Always disconnect DOC PRO from the charger before cleaning it with liquids.
•
Do not use thinners or other solvents to clean since they could damage surfaces.
•
Use a damp cloth to clean plastic parts.
•
Do not clean DOC PRO with pressure jets or by submerging it in water.
M
AINTENANCE AND REPAIRS
•
Frequently check the wheels and replace them when necessary.
•
If lock mechanisms loosen, tighten the screw using the supplied steel key, as illustrated.
Insert the steel key in the hole in the slot.
Move the steel bar in the"+" direction to tighten the slot until the handlebar no longer
wobbles.
•
To lengthen working life, avoid parking DOC PRO outdoors or in humid or wet areas.
•
Frequently clean the rear mudguard brake. Check correct brake operations by testing it at
low speed before use.
R
EMOVING THE FRONT WHEEL
Proceed as follows to change the front wheel:
Remove screws (AB) using the 5 mm Allen key, as shown in the fig.
Deflate the wheel to remove it (valve C). Loosen screws D, R, F, G and remove the wheel hub to remove
the wheel.
EN
11