Ice And Water Dispenser - Cafe CSB42 Manuel D'utilisation Et D'installation

Ice and Water Dispenser

To dispense water or ice: select
Water, Crushed, or Cubed.
Press the glass gently against the
top of the dispenser cradle.
The drip tray is not self-draining.
To reduce water spotting, the
shelf and its grille should be
cleaned regularly.
If no water is dispensed when
the refrigerator is first installed,
there may be air in the water
line system. Press the dispenser
cradle for at least two minutes
to remove trapped air from
the water line and to fill the water system. To flush out
impurities in the water line, throw away the first gallon
(3.8 liters) of water.
AutoFill (On some models)
To Use HANDS FREE AutoFill:
Center container on Recess Dispenser Tray without
activating paddle and remove hand from container
Press AutoFill.
To Stop AutoFill
Press ANY key, including AutoFill, to stop.
Important Facts about AutoFill
For optimum results, use a uniform container between
Fill level and functionality may vary on containers taller
given, try a different container.
AutoFill will time out.
Handles, straws, and garnishes on the rim of the
container my cause overfilling or variation in fill
volumes.
Splashing may occur depending on the location of the
container, water flow rate, container shape, and ice
cubes.
8
(On some models.)
CAUTION
objects into the ice crusher discharge opening.
Locking the Dispenser:
Touch Lock for 3 seconds to lock the dispenser and
control pad. To unlock, touch Lock again for 3 seconds.
Light:
This feature turns the light on and off. The light also
comes on when the dispenser cradle is pressed. If this
light burns out, contact factory service.
Drip Tray
not spray liquid or cleaners directly on sensors
AutoFill works best with household water pressure of
60 to 100 psi (414 to 689 kPa).
Ice in container may affect fill volume. If issues are
experienced, use less ice.
Never put fingers or any other
AutoFill Sensors
49-1000361 Rev. 2