3. Side Heat Shields; Brick Layout - England's Stove Works 13-NCMH Manuel D'installation Et De Fonctionnement

3. Side Heat Shields

This accessory
comes with the hardware
(six (6) mounting screws)
necessary to install it on
the rear of the stove. This
is a two-piece heat shield,
but is installed one piece at
a time. There are pre-
punched holes on each
side of the Rear Heat
Shield; while holding each
piece of the Side Heat
Shield in place, align the
pre-punched holes in the
Side Heat Shield with the
existing holes in the Rear
Heat Shield, and fasten
with the screws provided.
See Illustration 1 for
clearances with and without
side heat shields.
Illustration 4
1 – 9" x 4" x 1.25" brick (Qty. 11)
3 – 4" x 2.5" x 1.25" brick (Qty. 1)
5 – 4" x 4.5" x 1.25" brick (Qty. 1)
7 – 9" x 2.5" x 1.25" brick (Qty. 2)
item
Side
Heat
Shield
Illustration 3 – Side Heat Shield and Blower Installation

BRICK LAYOUT

Rear Heat Shield
Install AC-16 Optional
Blower on these (4) mounting
holes. See "Optional Blower
Instructions" on page 4 for
instructions.
2 – 9" x 4" x 1.25" brick w/ .75 x .75 notch (Qty. 2)
4 – 4.5" x 4" metal plate (Ash Drawer Plate, Qty. 1)
6 – 9" x 4" x 1.25" brick w/ 1" x 3" notch (Qty. 1)
13
Side
Heat
Shield